You have no items in your shopping cart.


Enviro-D-Rust is an aqueous neutral solution designed to be used as a soak immersion to remove all rust from steel and iron.Enviro-D-Rust is used at full strength with soak times as quick as 15 minutes to 24 hours in extreme cases at room temperature. Faster effectiveness may be achieved through heating. Since Enviro-D-Rustis neutral, no special equipment is needed, although safety glasses and gloves should be worn. The product can be used over and over again until it stops working. On average, a liter will de-rust up to 40 kg of light rusted steel.


-          No VOC’s

-          No dilution required

-          Biodegradable

-          Non-hazardous

-          Neutral pH (6.5 – 7.0)


Specific gravity


Solubility in water


Appearance and odour

Light yellow liquid, fruity odour

pH (concentrated)

6.5 – 7.0


Concentration: 100 % for most applications

Temperatures: 21 – 88°C

Equipment: Mild steel tanks and heating coils (optional)


Enviro-D-Rustshould be stored in the original containers in a well-ventilated area. Keep from freezing.


Enviro-D-Rustis irritating to eyes and skin. Avoid contact with skin and eyes. Suitable protective clothing, gloves, eye protection and respiratory protective equipment should be worn.

The safety procedures applicable to the handling of materials should be read, understood and rigidly adhered to. These are available on request from IMARK DISTRIBUTORS

The information contained in this bulletin is, to the best of our knowledge true and accurate, but any recommendations or suggestions which may be made, are without guarantee, since the conditions of use are beyond our control. Furthermore, nothing contained herein shall be construed as a recommendation to use any product in conflict with existing patents covering any material or it's use.


Safety Data Sheet

Date Issued: 20-07-2018
RM 9103 Blue

Company Details




St Martin Estate, R44,  Northern Paarl, 7623

1.Product and Company Identification

Trade / Commercial Name


Chemical Name

Aqueous solution


Chemical Family

Rust remover


Un No

Hazchem Code




2. Hazards Identification

Spilled substance increases risk of slipping
Irritating to skin and eyes

3. Composition

Hazardous Components


4. First Aid Measures

First Aid Skin

Wipe off excess material with cloth or paper. Wash with plenty of water or water and soap. Immediately take off contaminated clothing. Seek medical advise if irritation persists.

First Aid Eyes

Flush eyes with water for 15 minutes. hold eyelids open while washing. If irritation persists, obtain medical attention.

First Aid Ingested

Rinse mouth. Do NOT induce vomiting.

First Aid Inhalation

No special measures required.

5. Fire Fighting Measures

The product will not burn or support combustion. Use extinguishing media suitable for surroundings, such as dry chemical, CO2, water mist, alcohol resistant foam, sand.
Carbon oxides may be produced.
Wear chemical resistant protective equipment and self-contained breathing apparatus.

6. Accidental Release Measures

If material is released, indicate risk of slipping.
Contain (avoid spillage from entering drains, water courses, sewers and open soil).
Restrict access to area.
Provide adequate protective equipment and ventilation.
Remove sources of heat and flame.
Stop leak if you can do so without risk.
Take up with sand or other non-combustible absorbent material and place into containers for later disposal.
Clean any slippery coating that remains using a detergent/soap solution or a biodegradable cleaner.

7. Handling And Storage

Spilled substance increases risk of slipping.
Wear rubber gloves, goggles and chemical protective clothing.
Do not eat or drink when handling.
Keep containers tightly closed.
Do not allow material to freeze.

8. Exposure Controls/Personal Protection

Occupational Exposure Limits

Not established


The control measures appropriate for a particular worksite depend on how this material is used and on the extent of exposure.
The best protection is to enclose operations and/or provide local exhaust ventilation at the site of chemical release.
Use a non-sparking, grounded ventilation system separate from other exhaust ventilation systems. Exhaust directly to the outside.
Supply sufficient replacement air to make up for air removed.
Have a safety shower/eye wash fountain readily available in the immediate work area.

Personal Protection

If engineering controls and work practices are not effective in controlling this material, then wear suitable personal protection equipment, including chemical safety goggles & face shield, boots, impervious gloves, coveralls & respiratory protection.
Have appropriate equipment available for use in emergencies.
Observe standard industrial hygiene practice for the handling of chemical substances.
Do not eat, drink or smoke when handling.

9. Physical & Chemical Properties

Blue liquid, sweet odour
Boiling point: N/A
Relative density: 1.32
Vapour pressure @ 20°C: N/A
Vapour density: N/A
Flash point: None
Melting range: N/A
Auto-ignition temperature: N/A
Decomposition temperature: N/A
Viscosity at 25°C: Not available
pH: 6 - 8
Evaporation rate: N/A
Flammability: Not flammable
Solubility: N/A
Partition Coefficient; n-octanol/water: N/A
Upper/Lower flammability or explosive limits: N/A

10. Stability And Reactivity

Conditions to Avoid

Stable under normal conditions.

Incompatible Materials

Strong oxidisers and strong acids.


Stable at ambient conditions.
Hazardous decomposition products: Carbon oxides may be produced when involved in a fire.
Hazardous polymerisation will not occur .

11. Toxicological Information

Irritating to skin and eyes

12. Ecological Information

Readily biodegradable.
The product disperses in water.
Bioaccumulation: Unlikely
Ecotoxicological effects: No data available

13. Disposal Considerations

Disposal Method Product

We recommend that you contact the authorities in charge or approved waste disposal companies which will advise you on how to dispose of special waste.

Disposal Method Packaging

Disposal in accordance with local legal provisions.
Comtainers may be recycled or re-used

14. Transport Information




IMDG-Shipping Name


Marine Pollutant



Not Controlled

Subsidiary Risks


15. Regulatory Information

EEC Hazard Classification

Risk Phases

Safety Phases

Keep containers tightly closed.
Avoid contact with eyes and skin.
Wear suitable protective clothing, goggles and gloves

National Legislation

National Road Traffic Act 1996 (Act 93 of 1996)
Occupational Health and Safety Act 1993 (Act 85 of 1993)
Hazardous Substances Act 1973 (Act 15 of 1973)

16. Other Information

This document has been drafted with reasonable regard to the information available to us, and as accurately as is reasonably practicable.
It characterizes the product with regard to the appropriate safety precautions.
It does not represent a guarantee of the properness of the product
Date issued: 04/07/2018
Revision No.: 0

All information is given in good faith but without guarantee in respect of accuracy & no responsibility is accepted for errors or omissions or the consequences thereof.